full mineral coating on both sides
article number 070486
joint sheet metal - packing 50 pieces
length 2400 mm, width 120 mm
55 pcs fixing clips
150 pcs mounting brackets
The elements must overlap at
least 20 cm in the area of joint !!
General Building Supervisory Board Test Certificate by MPA Braunschweig
Add to notice list
The most important information at a glance
start Animation
St 37, galvanized
special coating: mineral
hard, rough
2.40 m
120 mm
approx. 0.6 mm
approx. 0.4 mm
approx. 1.0 mm
General Building Supervisory Test Certificate (AbP)
MPA Braunschweig
No.: P-1200/691/17 MPA-BS
Assessment report; storage in liquid manure, slurry,
silage effluent
MPA Braunschweig
(1200/549/17) - Pan
yes
Utility class A for the wear classes 1 and 2 in
accordance with the WU guideline
Store in undamaged and unopened original
packaging in a dry place out of direct sunlight.
regulations.
The product is delivered in a wooden crate.
The Joint sheet metal MB Overlap elements and the fixing clips are in the crate.
Joint sheet metal MB Overlap elements are supplied ready to install.
A protective foil does not need to be removed.
Place the elements in the centre of the rising wall on top of the upper reinforcement layer.
Push the mounting brackets, 3 pcs/element, over the sheet metal and fix them to the upper reinforcement layer with binding wire.
The embedment depth in the concrete must be at least 3 cm and must not be more than half the height of the sheet metal (8 cm).
The joint of the Joint sheet metal MB Overlap can be made without glue, only by overlapping the two ends.
The length of the overlap must be at least 20 cm.
There must be no contamination on the surfaces that could interfere with bonding.
The joint must be secured with one of the fixing clips provided.
Attention: The Joint sheet metal MB Overlap must not be plugged into the fresh concrete subsequently.
Corners can be formed by sharp-edged bending in-situ on the
building site.
After some alignment the edge can be fixed on the reinforcement.
To facilitate the fixing of the Joint sheet metal MB Overlap on the reinforcement start installation in a corner.
The placement of concrete in the area of the Joint sheet metal MB Overlap and corresponding preparations must be carried out in accordance with the established technical standards.
Status: 23.03.2022
Accessories
suitable accessories
for securing the element joints ...
Contact us
We are happy to answer your questions