250 mm - with "onion ring" technology - split version
article number 120222T
The most important information at a glance
rubber: EPDM
sealing width: 40 mm
pressure plates, screws, nuts: V2 A
pressure plates: silvery
M8
13 mm
10 Nm at form stable media pipes
250 mm
Without Plug: 158 - 160 mm
1. Ring: 168 - 170 mm
2. Ring: 178 - 180 mm
3. Ring: 198 - 200 mm
4. Ring: 208 - 210 mm
Adjust the sealing insert of the MASTER-Ring Multi split version to the diameter of the media line. To do this, push the required rings backwards through the seal.
Remove the locking clip of the MASTER-Ring Multi split version
Open the gasket on the side of the puzzle pieces.
Place the MASTER-Ring Multi split version around the installed pipe.
Close the gasket and reinstall the locking clip and close it as well.
Push the seal into the annular gap.
Tighten the screws crosswise through one turn.
Tighten the screws to the specified max. torque. (Ø 100/150/200 = 5Nm; Ø250 = 10Nm).
Check the torque after 1-2 hours and retighten the screws if necessary.
Contact us
We are happy to answer your questions