Tüüp 3-katusega
Artikli number 046330
Kinnituspunktide poltidega sulgemine - maksimaalne ohutus koos silmapaistva välimusega
Lisada märkuste loetelluKõige olulisem teave lühidalt
start Animatsioon
Mutter: hõbedane
Surveketas: hõbedane
Tihenduskumm: must
Küüs: roheline
17 kuni 19,5 mm
28 mm
75 mm
Ei
Ja
Scope of delivery
The STOPPER SCREW type covered is delivered ready for installation in a plastic bucket (100 pcs.). Each bucket contains 4 bits, which are attached to the inside of the lid. (Type 6: 50 pcs. and 2 bits)
Installation tools
For installation you need:
- Cleaning brush
- Cordless screwdriver
- Hammer for driving in and positioning
- Torque control tool
Preparation of tie point
Clean the inside of the tie point. Remove loose particles and dust before installation of STOPPER SCREW type covered .
1. Insertion
Insert the STOPPER SCREW type covered into the clean tie point to be sealed. To do this, position the claw of STOPPER SCREW type covered in such a way that all 4 claw ends are inside the clearance of the tie point. With a hammer blow onto the pressure plate the claw of STOPPER SCREW type covered slips into the tie point and centres itself.
2. Positioning
Push or hammer the STOPPER SCREW type covered completely into the tie point.
3. Tightening
Tighten the screw of STOPPER SCREW type covered with a cordless screwdriver. Use speed class 1.
Then tighten the screw of the STOPPER SCREW type covered with the torque wrench to a torque of 4Nm (5Nm for conical anchor holes).
With our STOPPER SCREW torque set, this step can be done more easily.
STOPPER SCREW type covered mounted in tie point with cone.
Status: 14.12.2022
Tarvikud
sobivad tarvikud
Võtke meiega ühendust
Vastame hea meelega teie küsimustele