STOPPER SCREW 20-in (19.5-22 mm)

STOPPER SCREW 20-in (19.5-22 mm)
Tip 4-in

številka izdelka 046240

STOPPER SCREW

Vijačno zapiranje vpenjalnih točk opaža - največja varnost in izjemen videz

Dodaj na seznam obvestil

Najpomembnejše informacije na prvi pogled

začetek Animacija

Tehnični podatki

številka izdelka:

046240

skupina člankov:

611 - Stopper Screw + Zubehör

GTIN:

4251689538049

številka carinske tarife:

39259080

pakirna enota:

Vedro

prodajna količina enota:

100 Stk

teža na:

Vedro = 3.1 kg

material:

Vijak / matica / tlačni disk: nerjavno jeklo V2A

Gumijasto tesnilo: termoplastični elastomer

Pogon: polioksimetilen

barva:

Vijak: srebrn
Matica: srebrna
Tlačni disk: srebrn
Tesnilna guma: črna
krempelj: zelen

Notranji premer vpenjalne točke:

19,5 do 22 mm

Skupna dolžina:

72 mm

Vsebuje snovi s seznama SVHC ali sorazmerno maso ≥0,1 %.:

Izdelek je skladen z uredbo REACH:

vodotesnost zaradi vodnega tlaka:

do 4 barov

shranjevanje:

Shranjujte v nepoškodovani in neodprti originalni embalaži na suhem mestu, stran od neposredne sončne svetlobe.

odstranjevanje:

Lahko se odstrani na odlagališčih ali v sežigalnicah v skladu z lokalnimi predpisi o odstranjevanju odpadkov.

Podatkovni list

Navodila za namestitev

Scope of delivery

The STOPPER SCREW type in is delivered ready for installation in a plastic bucket (100 pcs.). Each bucket contains 4 bits, which are attached to the inside of the lid. (Type 6: 50 pcs. and 2 bits)

Installation tools
For installation you need:

- Cleaning brush
- Cordless screwdriver
- Hammer for driving in and positioning
- Torque control tool

Preparation of tie point

Clean the inside of the tie point. Remove loose particles and dust before installation of STOPPER SCREW type in.

1. Insertion

Insert the STOPPER SCREW type in into the clean tie point to be sealed. To do this, position the claw of STOPPER SCREW type in in such a way that all 4 claw ends are inside the clearance of the tie point. With a hammer blow onto the pressure plate the claw of STOPPER SCREW type in slips into the tie point and centres itself.

2. Positioning

Push or drive the STOPPER SCREW type in into the desired position in the tie point. For a flush seal, after tightening, the untensioned STOPPER must protrude approx. 7 mm above the tie point.

Alternatively with STOPPER SCREW positioning aid

The use of the STOPPER SCREW positioning aid makes positioning much easier due to the recess on the front side.

3. Tightening

Tighten the screw of STOPPER SCREW type in with a cordless screwdriver. Use speed class 1.

Then tighten the screw of the STOPPER SCREW type in with the torque wrench to a torque of 4Nm (5Nm for conical anchor holes).
With our STOPPER SCREW torque set, this step can be done more easily.