STOPPER SCREW 28-covered (27.5-29 mm)

STOPPER SCREW 28-covered (27.5-29 mm)
Tip 7 s pokrovom

številka izdelka 046370

STOPPER SCREW

Vijačno zapiranje vpenjalnih točk opaža - največja varnost in izjemen videz

Dodaj na seznam obvestil

Najpomembnejše informacije na prvi pogled

Tehnični podatki

številka izdelka:

046370

skupina člankov:

611 - Stopper Screw + Zubehör

GTIN:

4251689538155

številka carinske tarife:

39259080

pakirna enota:

Vedro

prodajna količina enota:

100 Stk

material:

Vijak / matica / tlačni disk: nerjavno jeklo V2A

Gumijasto tesnilo: termoplastični elastomer

Pogon: polioksimetilen

barva:

Vijak: srebrn
Matica: srebrna
Tlačni disk: srebrn
Tesnilna guma: črna
krempelj: zelen

Notranji premer vpenjalne točke:

27,5 - 29 mm

Ø potisna podložka:

32 mm

Skupna dolžina:

75 mm

Vsebuje snovi s seznama SVHC ali sorazmerno maso ≥0,1 %.:

Izdelek je skladen z uredbo REACH:

vodotesnost zaradi vodnega tlaka:

do 4 barov

shranjevanje:

Shranjujte v nepoškodovani in neodprti originalni embalaži na suhem mestu, stran od neposredne sončne svetlobe.

odstranjevanje:

Lahko se odstrani na odlagališčih ali v sežigalnicah v skladu z lokalnimi predpisi o odstranjevanju odpadkov.

Podatkovni list

Navodila za namestitev

Scope of delivery

The STOPPER SCREW type covered is delivered ready for installation in a plastic bucket (100 pcs.). Each bucket contains 4 bits, which are attached to the inside of the lid. (Type 6: 50 pcs. and 2 bits)

Installation tools
For installation you need:

- Cleaning brush
- Cordless screwdriver
- Hammer for driving in and positioning
- Torque control tool

Preparation of tie point

Clean the inside of the tie point. Remove loose particles and dust before installation of STOPPER SCREW type covered .

1. Insertion

Insert the STOPPER SCREW type covered into the clean tie point to be sealed. To do this, position the claw of STOPPER SCREW type covered in such a way that all 4 claw ends are inside the clearance of the tie point. With a hammer blow onto the pressure plate the claw of STOPPER SCREW type covered slips into the tie point and centres itself.

2. Positioning

Push or hammer the STOPPER SCREW type covered completely into the tie point.

3. Tightening

Tighten the screw of STOPPER SCREW type covered with a cordless screwdriver. Use speed class 1.

Then tighten the screw of the STOPPER SCREW type covered with the torque wrench to a torque of 4Nm (5Nm for conical anchor holes).
With our STOPPER SCREW torque set, this step can be done more easily.