Tesnilna pasta FLEX 2000

Tesnilna pasta FLEX 2000
Paroprepustna in vodotesna tesnilna masa

številka izdelka 120610

FLEX 2000

Dodaj na seznam obvestil

Najpomembnejše informacije na prvi pogled

Tehnični podatki

številka izdelka:

120610

skupina člankov:

450 - Flex 2000 + Zubehör

GTIN:

4251689531408

številka carinske tarife:

32149000

pakirna enota:

računalnik

prodajna količina enota:

1 Stk

teža na:

računalnik = 0.9 kg

material:

Poliolefin

barva:

Razred

gostota:

1,6 g/cm³ (DIN EN ISO 1183-1)

Konsistenz:

pasty, stabilen

Vonj:

Brez kisika

Vsebnost topila:

Brez topil

Temperatura obdelave:

appox. + 5 ° C bis +35° C

Temperatura substrata:

approx. + 5 ° C bis +35° C

Poraba:

približno 1,6 kg/liter prostora

Potrdilo o preskusu / pooblastila:

Preiskovalno poročilo
MFPA Leipzig
št.: U / 5.1 / 08 - 043

Čiščenje naprav:

Po uporabi z univerzalnim čistilom

Trajanje shranjevanja:

Pri 20 °C približno 2 leti

vodotesnost zaradi vodnega tlaka:

do največ 0,75 bara ( 7,5 m vodnega stolpca )

shranjevanje:

Shranjujte v nepoškodovani in neodprti originalni embalaži na suhem mestu, stran od neposredne sončne svetlobe.

odstranjevanje:

Lahko se odstrani na odlagališčih ali v sežigalnicah v skladu z lokalnimi predpisi o odstranjevanju odpadkov.

Podatkovni list

Navodila za namestitev

Preparation:

The substrate must be free from grease, tar, oil and loose particles.
Suitable substrates are: concrete, brick, mortar, plaster and all other mineral construction materials, as well as ceramics, PVC, polyethylene and polypropylene.
Clean the inside of the duct using a suitable brush to remove dust, sand, and any loose particles.

Prior to application, FLEX 2000 is warmed to approx. 35 - 40 °C by placing in hot water to ensure optimum consistency and workability

Installation:

Before applying FLEX 2000, a securing block of a two-component PUR foam is applied in the duct at a depth of approx. 15 cm.
The FLEX 2000 cartridge is then inserted into the cartridge applicator and FLEX 2000 paste injected into the annular gap of the two-component securing block, starting at the back and working towards the front.The layer must be at least 12 cm thick.
After sealing cable ducts, jiggle the cables slightly and fill any cavities with FLEX 2000.
Always ensure that the cable is free of tension and strain after sealing.The sealing compound is then pressed in firmly and smoothed with a metal filler knife leaving a depression approx. 1 cm deep, which is sealed with fast-curing cement to additionally secure the mouth of the duct.
To feed through a new cable, the mortar cap is removed and the cable is pushed through the sealing compound. The duct is then re-sealed using FLEX 2000.

Inflowing water