från natriumbentonit
artikelnummer 010012
MASTERSTOP "LONG TIME" bentonit svällande tejp för säker tätning av konstruktionsfogar och genomföringar i betongkonstruktioner mot inträngande vatten. Vatteninträngning förhindras av svällningen och det svälltryck som skapas under svällningsprocessen.
MASTERSTOP LONG TIME bentonite swelling tape är en tätning som kan svälla i vatten. Den består av finmalt, mycket svällbart lermineral (natriumbentonit), inbäddat som bindemedel i en matris av icke-vulkaniserat gummi. För bättre väderbeständighet är den belagd med en film som löser upp sig själv i betongen. Lägg till i meddelandelistanDen viktigaste informationen i en överblick
Natrium bentonit
Smidig
Plastik
Upp till 340 % i normalt vatten (PH 7)
.
upp till 150 % i vätskor som kraftigt angriper betong
upp till 290
upp till 290 % i alkaliska vätskor
Nej
Ja
Nej
Ja
ETA - 16 / 0735
.
Allmänt testcertifikat för byggnadsmyndighet (AbP), MFPA Leipzig
Nr: P-SAC 02 / 5.1 / 15-253
Cirka 10 dagar
utförs ca 6-7 dagar efter betongtillverkning
Ja
Användningsklass A för lastklass 1 och 2 i enlighet med WU:s riktlinjer
Since the MASTERSTOP "LONG TIME" is supplied with a protective sheating, the swelling tape can
only be fastened by using a special swelling tape grid.
The substrate must be clean, dry and free of loose parts.
Apply the MASTERSTOP "LONG TIME" in the middle of the joint to the concrete surface and fix it.
The later concrete cover must be at least 8cm.
The swelling tape must be bordered by reinforcement on both sides.
Minimum distance to the reinforcement: 5cm.
Place the swelling tape grid carefully over the swelling tape without damaging the protective sheating.
The grid must only be nailed on through the side wings.
Fasten with suitable nails either by hand or mechanically with a bolt-firing tool.
The distance between nails should not exceed 25 cm in the longitudinal direction of the swelling tape.
At the beginning of the tape and if tape sections are used, pull back the protective sheating approx. 5 cm, cut off the swelling tape and fold over the extra length of sheating to prevent contact with water.
In the corners, the swelling tape grid must be released in order to ensure a continuous firm fixation on the substrate.
In the case of butt joints in the straight line and the use of swelling tape grids, the joints of swelling tape and swelling tape grid should always be made in a staggered position.
Status: 23.03.2022
Tillbehör
lämpliga tillbehör
Galler för svällande bälte för MASTERSTOP. "LONG TIME" 25/20, längd 1 m ...
Längd 42 mm med stor skiva ...
Längd 40 mm med skiva ...
Liknande produkter
Du hittar liknande produkter här.
Detta är ett test...
Kontakta oss
Vi svarar gärna på dina frågor