entièrement revêtu sur les deux faces
numéro d'article 070464
Rouleaux de tôle d’étanchéité VB
L'étanchéité des joints de construction en béton est soumise à de hautes exigences.
Les tôles d'étanchéité revêtues d'un côté ou des deux côtés, Dichtblech Rolle 120 VB1 ou VB2, garantissent une étanchéité sûre et durable des joints de construction en béton contre l'eau sous pression et sans pression.
Aperçu des informations les plus importantes
St 37, galvanisé
.
Revêtement spécial : Plastique polymère renforcé par un tissu
20 m
La sécurité des personnes et des biens est un élément essentiel de la sécurité.
120 mm
La sécurité de l'homme et de l'environnement est un enjeu majeur.
Approximativement 0,15 mmm
La valeur de l'échantillon est de 0,15 mmm
.
Environ 0,9 mm
Certificat d'essai général de la surveillance des chantiers (AbP)
MFPA Leipzig
ja
Classe d'utilisation A pour les classes de sollicitation 1 et 2, conformément à la directive WU
.Non
Ja
Ja
Carton ( 40 x 40 x 20 cm)
1 rouleau
2 pièces d'attaches de butée
30 étriers de fixation
48 cartons par palette
Remove the bottom half of the parted protective foil from the special coating.
Place the VB joint sheet metal in the centre of the rising wall on top of the upper reinforcement layer.
Push the mounting brackets with a maximum distance of 70 cm over the sheet metal and fix them to the upper reinforcement layer with binding wire.
The embedment depth in the concrete must be at least 3 cm and must not be more than half the height of the sheet metal.
PLEASE NOTE!! The coating of the joint sheet metal VB1 must face the waterlogged side!
The VB joint sheet metal must overlap by at least 6 cm in the area of the joint, in the straight sections and also in the corner area.
To do so, the upper protective foil must be turned back in the area subsequently to be joined.
Overlap the VB joint sheet metal by at least 6 cm and press the two ends firmly together.
The joint must be glued over its full height and entire surface to prevent subsequent water permeation.
There must be no contamination on the adhesive surfaces that could interfere with bonding.
Secure the joint with one of the fixing clips provided and fold the protective foil back onto the special coating.
Prepared joints in the straight sections as well as the corner area.
Once the foundation slab has been concreted, and before the wall formwork is closed or the double wall elements have been set up, the remaining protective foil must be removed.
The concreting of the wall base and corresponding preparations must be carried out in accordance with the established technical standards.
Status: 23.03.2022
Contactez nous
We are happy to answer your questions