Tappo di tenuta in plastica solida
numero di articolo 046160
Impermeabilizzazione interna per spessori di parete in plastica e fibrocemento
Aggiungi all'elenco degli avvisiLe informazioni più importanti in un colpo d'occhio
TPE - Elastomero termoplastico
Per diametro interno da 21,5 a 23 mm
ca. 70 ± 5 Shore A
Rapporto di prova
MFPA Lipsia
PB P 5.1/15-012
Test JGS
MPA Braunschweig
(1200/442/15c) - Pan
Es. liquami, letame liquido, infiltrazioni di insilati, gas metano, radon, radiazioni UV, ozono, bitume
250 pezzi / secchio
No
Ja
Classe "E", secondo DIN-EN 13501-1
Required tooling:
Hard rubber mallet: 1500 - 2000 g
Cleaning brush for tube 21.5 - 26 mm ( Art.-Nr.: 046170)
Drive-in aid ( Art.-Nr.: 046180 )
Soiled distance tubes must be thoroughly cleaned before installing the STOPPER.
The entire installation area must be properly cleaned as otherwise it will not be possible to drive in the STOPPER to its final depth.
The STOPPER maxi can only be used as the outer closure of the distance tube if cones are used.
The STOPPER maxi is installed by driving it in with a hard rubber mallet (weight 1500 - 2000 g) using reasonable force.
The STOPPER maxi must be driven in to its full depth, i.e. flush with the concrete surface.
!! The STOPPERS must always be driven in at both ends of the distance tube !!
When driving in the second STOPPER maxi on the other end of the tube, it may appear that it is not possible to drive it in completely. This is due to compressed air trapped between the two STOPPERS.
If this situation occurs, simply wait and give the air time to escape before continuing to drive in the STOPPER into its final position.
Status: 23.03.2022
Accessori
accessori adatti
Prodotti simili
Potete trovare prodotti simili qui.
Impermeabilizzazione interna per spessori di parete in plastica e fibrocemento ...
Impermeabilizzazione interna per spessori di muro in plastica e fibrocemento ...
Contattateci
Siamo lieti di rispondere alle vostre domande