angličtina
Plne potiahnuté na oboch stranách s podstavcom
číslo článku 070468
VB spojenie plechu vo zvitkoch
Tesnenie škár betónových konštrukcií kladie vysoké nároky na technológiu tesnenia.
Plne potiahnuté tesniace fólie Rolle-F tesniaca fólia s podkladom zabezpečujú bezpečné a trvalé utesnenie betónových stavebných škár proti tlakovej a netlakovej vode.
Najdôležitejšie informácie na prvý pohľad
St 37, pozinkovaná
Špeciálna povrchová úprava: polymérový plast vystužený tkaninou
20,00 m
160 mm
O 0,6 mm
O 0,15 mm
O 0,9 mm
Osvedčenie o skúške všeobecného stavebného úradu (AbP)
MFPA Lipsko
ja
Triedu A použite pre triedy zaťaženia 1 a 2 v súlade s usmernením WU
Nie
Ja
Kartón (40 x 40 x 20 cm)
1 rolka
2 upevňovacie konzoly
36 krabíc na palete
Technická skúška použitia do 8 barov
Packaging
1 Role with 20 m
2 fixing clips
Remove the bottom half of the parted protective foil from the special coating.
Place the Joint Sheet Metal Role-F on the top reinforcement in the center of the rising wall. Use binding wire to tie the fastening foot to the reinforced layer. The emedment depth in the concrete must be at least 3 cm and must not exceed half of the sheet height (8 cm).
By bending and crimping a festenig foot to the opposite side (approx. every 50 cm) the position of the sheet can be addtionally stabilized.
In the corner area, the sheet is bent according to the course of the corner. It is advisable here to bend over a "sharp" edge.
At transition joints, the Joint Sheet Metal Role-F must be overlapped by at least 6cm. For this purpose, the protective film is folded badk along the length of the overlap.
The overlapping surfaces are pressed together over the entire surface and secured with one of the supplied fixing clips. Ther must be no dirt on the adhesie surfaces that could impair the bonding.
The Joint Sheet Metal Role-F must form a self-contained, defect-free circuit. The upper half of the protective film must remain on the special coating until the latest possible time. The concreting of the wall base and the corresponding preparations for this must be carried out in accordance with the recognized technical regulations.
Status: 23.03.2022
Kontaktujte nás
Radi vám odpovieme na vaše otázky