Engels
Aan beide zijden volledig gecoat met basis
artikelnummer 070468
Het afdichten van betonconstructievoegen stelt hoge eisen aan de afdichtingstechniek.
De volledig gecoate afdichtingsplaten Rolle-F afdichtingsplaat met voet zorgen ervoor dat de betonconstructievoegen veilig en duurzaam worden afgedicht tegen drukkend en niet drukkend water.
De belangrijkste informatie in één oogopslag
St 37, verzinkt
Speciale coating: weefselversterkt polymeer kunststof
20,00 m
160 mm
Op ongeveer 0,6 mm
Op ongeveer 0,15 mm
Op ongeveer 0,9 mm
Algemeen bouwtoezicht testcertificaat (AbP)
MFPA Leipzig
ja
Gebruiksklasse A voor belastingsklasse 1 en 2 volgens de WU-richtlijn
Nee
Ja
Karton (40 x 40 x 20 cm)
1 rol
2 bevestigingsbeugels
36 dozen per pallet
Technische toepassingstest tot 8 bar
Packaging
1 Role with 20 m
2 fixing clips
Remove the bottom half of the parted protective foil from the special coating.
Place the Joint Sheet Metal Role-F on the top reinforcement in the center of the rising wall. Use binding wire to tie the fastening foot to the reinforced layer. The emedment depth in the concrete must be at least 3 cm and must not exceed half of the sheet height (8 cm).
By bending and crimping a festenig foot to the opposite side (approx. every 50 cm) the position of the sheet can be addtionally stabilized.
In the corner area, the sheet is bent according to the course of the corner. It is advisable here to bend over a "sharp" edge.
At transition joints, the Joint Sheet Metal Role-F must be overlapped by at least 6cm. For this purpose, the protective film is folded badk along the length of the overlap.
The overlapping surfaces are pressed together over the entire surface and secured with one of the supplied fixing clips. Ther must be no dirt on the adhesie surfaces that could impair the bonding.
The Joint Sheet Metal Role-F must form a self-contained, defect-free circuit. The upper half of the protective film must remain on the special coating until the latest possible time. The concreting of the wall base and the corresponding preparations for this must be carried out in accordance with the recognized technical regulations.
Status: 23.03.2022
Contact us
We beantwoorden graag je vragen